Blue and red
insulated wires run through a sticker backed aluminum foil coil sheet.
We take no responsibility for customers who try it on
their own.
Never forget to replace insulation for towel heating and safety of
unit.
1. Unplug the unit,
2. Remove the back screws
3. Carefully remove
insulation with gloves on
4. Do Not Discard Insulation!
5. Find blue and red wires and mark
clearly which
color goes to which junction.
6. Once this is done remove the old
sticker material carefully to get it in 1 piece.
7. There may be 2 so be careful and check for both
or 1 sticker unit similar to what you see in the photo.
8. Take the new heater coils and fit in place
to see if it
indeed will fit correctly.
9. Then remove and take adhesive backing off new
coil.
10. Carefully fix sticker coil inside unit with wires facing to junction
11. Plug junction
wires into correct plug already marked before you
disconnected it at the beginning.
12. Check
to make sure junction wires are in the correct place before proceeding.
Replace loosely the backing
and turn the unit on to test heater. if OK,
13. Turn off unit, unplug and carefully place back insulation in
back or sides.
THIS IS ESSENTIAL AND MUST BE DONE OR YOU COULD START A
FIRE
If you do not have the insulation you can easily get some from a hardware
store,
It is the same kind as in refrigerators insulation or even air conditioning thin
insulation.
14. Replace screws
15. Plug in and enjoy your towel warmer.
Please make sure to order the correct parts. There is a 25% restocking fee if needing
to be returned. Call for return authorization please if this should occur,
Call
with questions please. Toll free 1-888-616-9450 / local or international dial 1-630-616-
9450
